Digital LN15 Guía de instalación descargar pdf (Pagina 21)

Installation Guide DIGITAL Laser Printer LN15 21

Open the duplexer rear stacker.

Open the metal paper support from

inside the stacker.

Set the paper path selector lever to

the stacker position ‘

’ (‘

’ is the

duplexer position).

NOTE Setting the paper path selector to the stacker

position ‘B’ and not opening the stacker, will always

result in a paper jam.

2.11. CONNECTING THE POWER CORD

Plug the female end of the power

cord in the connector on the rear

of the printer. Plug the opposite

end of the power cord in a

grounded AC outlet.

Turn the printer on (press down

the ‘|’ side of the switch). After a

brief warm-up (less than 2

minutes) the printer is ready.

2.12. PRINT A TEST PAGE

At this point you have set up your printer. It is recommended to do a simple test to

verify your setup. As soon as the message window on the control panel displays

‘READY’, press the following keys:

1. Press ‘

READY

’ (the online LED goes off).

2. Press ‘

SELFTEST

’ for more than 5 seconds.

After a while, the printer prints a status report.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sin comentarios

Digital LN15 Guía de instalación Pagina 21