Digital LG plus Series Manual de instrucciones descargar pdf (Pagina 151)

5–47

Replacement Procedures and

Illustrated Parts List

Installation

1. Holding the slotted wheel against the PMD sensor, position the paper

detector switch assembly and install the screws securing it to the printer

base. (See Figure 5–15, page 5–69, item 4.)

2. Check PMD sensor arm range: make sure it travels freely and completely

back into the sensing cavity.

3. Route the switch cable back to the controller board, installing the cable

in the restraints under the base casting. (See cable routing diagram on

page A–10.)

4. Connect the paper detector switch cable to the connector shell (page

5–8), then connect the connector shell P106 to the controller board.

5. Install the barrier shield and tighten the four screws. (See page 5–59,

Figure 5–10, items 3, 4, and 9.)

6. Install the paper path (page 5–29).

7. Check and adjust the End of Forms Distance (page 4–20).

8. Return the printer to normal operation (page 4–3).

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 249 250

Sin comentarios

Digital LG plus Series Manual de instrucciones Pagina 151